应用化学 ›› 2018, Vol. 35 ›› Issue (2): 232-238.DOI: 10.11944/j.issn.1000-0518.2018.02.170083

• 研究论文 • 上一篇    下一篇

基于三氯化铁催化作用制备大尺寸氧化石墨烯薄膜

李占国a,范思大ab,张梁b,张沛沛ab,孙丽晶b,尹丽b,张吉东c,王丽娟b*()   

  1. a长春理工大学光电工程学院 长春 130022
    b长春工业大学化学工程学院 长春 130012
    c中国科学院长春应用化学研究所 高分子物理与化学国家重点实验室 长春 130022
  • 收稿日期:2017-03-24 接受日期:2017-06-26 出版日期:2018-02-01 发布日期:2018-01-29
  • 通讯作者: 王丽娟
  • 基金资助:
    国家自然科学基金项目(21403016);吉林省教育厅项目(2016326和JJKH20170556KJ);吉林省科技厅重点攻关项目(20170204014SF)

Preparation of Large-size Graphene Oxide Films Based on Iron(Ⅲ) Chloride Catalysis

LI Zhanguoa,FAN Sidaab,ZHANG Liangb,ZHANG Peipeiab,SUN Lijingb,YIN Lib,ZHANG Jidongc,WANG Lijuanb*()   

  1. aSchool of Electro-Optical Engineering,Changchun University of Science and Technology,Changchun 130022,China
    bSchool of Chemical Engineering,Changchun University of Technology,Changchun 130012,China
    cState Key Laboratory of Polymer Physics and Chemistry,Changchun Institute of Applied Chemistry,Chinese Academy of Sciences,Changchun 130022,China
  • Received:2017-03-24 Accepted:2017-06-26 Published:2018-02-01 Online:2018-01-29
  • Contact: WANG Lijuan
  • Supported by:
    Supported by the National Natural Science Foundation of China(No.21403016), the Scientific Research Foundation of Education Department of Jilin Province(No.2016326, No.JJKH20170556KJ), the Key Program for Science and Technology Development of Jilin Province of China(No.20170204014SF)

摘要:

本文用三氯化铁(FeCl3)作催化剂制备了大面积的氧化石墨烯(L-GO)薄膜。 通过原子力显微镜(AFM)、偏光显微镜(POM)、红外光谱(FTIR)、X射线衍射(XRD)对FeCl3催化剂存在下,不同温度和时间得到的L-GO薄膜进行形貌和结构研究。 结果表明,在 FeCl3催化下L-GO薄膜片畴的面积为10 μm×10 μm,与无催化作用得到的GO薄膜相比增加了大约4倍。 从FTIR和XRD分析可以确定,大尺寸片畴的形成可以归因于催化作用促进了氧化石墨上的羟基、羧基、羰基等含氧官能团重新组合和连接。 据此,提出了FeCl3催化下L-GO薄膜形成模型,为制备大面积石墨烯薄膜提供了新的途径。

关键词: 三氯化铁, 催化剂, 片状氧化石墨烯, 大尺寸薄膜, 表面形貌, 红外光谱

Abstract:

In order to obtain large-area graphene oxide(L-GO) films, a series of FeCl3-catalyzed L-GO films are prepared. The surface morphology and structure of L-GO films synthesized with various temperatures and times are studied by atomic force microscope(AFM), polarizing microscope(POM), Fourier transform infrared spectrometer(FTIR), and X-ray diffraction(XRD). The sheet domain area of FeCl3-catalyzed L-GO films is 10 μm×10 μm, which increases about four times in contrast to that of GO films prepared without catalyst. By further analysis of FTIR and XRD, the formation of L-GO domains can be attributed to the new connections of the hydroxyl, carboxyl, and carbonyl groups in graphene oxide under FeCl3 catalysis. Thus, a formation model of FeCl3-catalyzed L-GO films is proposed, which provides a new way for the preparation of large area graphene oxide films.

Key words: iron chloride, catalyst, graphene oxide sheet, large-size thin film, surface morphology, Fourier transform infrared spectroscopy