应用化学 ›› 2020, Vol. 37 ›› Issue (2): 218-226.DOI: 10.11944/j.issn.1000-0518.2020.02.190235

• 研究论文 • 上一篇    下一篇

钛丝原位组装固相微萃取涂层与高效液相色谱联用测定多环芳烃

马明广,魏云霞()   

  1. 兰州城市学院化学化工学院 兰州 730070
  • 收稿日期:2019-09-03 接受日期:2019-11-20 出版日期:2020-02-01 发布日期:2020-02-06
  • 通讯作者: 魏云霞
  • 基金资助:
    甘肃省科技计划项目(18JR3RA219)和兰州城市学院博士科研启动金(LZCU-BS2018-29)资助

Fabrication of Solid Phase Microextraction Fibers of Titanium Wires and Its Application

MA Mingguang,WEI Yunxia()   

  1. College of Chemistry and Chemical Engineering,Lanzhou City University,Lanzhou 730070,China
  • Received:2019-09-03 Accepted:2019-11-20 Published:2020-02-01 Online:2020-02-06
  • Contact: WEI Yunxia
  • Supported by:
    Supported by the Science and Technology Program of Gansu Province(No.18JR3RA219), and the Ph.D. Research Initiation Fund of Lanzhou City College(No.LZCU-BS2018-29)

摘要:

利用恒电势法在钛丝表面原位阳极氧化组装固相微萃取(SPME)纤维,通过考察不同浓度电解质溶液和电解时间对二氧化钛纳米管(TiO2NTs)形成及尺寸的影响来确定最佳的SPME纤维的形貌。 结果表明,NH4F在水相中的质量分数为0.5%,乙二醇在水相中的体积分数为50%,氧化电势为20 V,温度为25 ℃,氧化时间30 min的条件下,得到内径为100 nm,壁厚为25 nm的有序纳米管排列。 利用组装得到的二氧化钛纳米管纤维涂层(TiO2NTs/Ti)与高效液相色谱(HPLC)联用测定水样中的多环芳烃(PAHs)。 在优化的萃取条件下,该方法灵敏度高,线性范围宽,选择性和重复性好,操作简便。 利用此方法测量了实际水样中的PAHs浓度,得到了令人满意的分析结果。

关键词: 二氧化钛纳米管, 组装, 固相微萃取, 多环芳烃

Abstract:

In this article, solid phase microextraction (SPME) fibers were assembled by in situ anodization on the surface of titanium wire with a constant voltage and anodization time. Effect of the electrolyte solutions of different concentrations (concentration of NH4F and ethylene glycol) and electrolysis time on the formation and size of TiO2 nanotubes (TiO2NTs) was investigated. TiO2NTs arrays were arranged with the wall thickness of 25 nm and the pore diameter of 100 nm in ethylene glycol and water (volume ratio 1:1) containing 0.5% mass fraction of NH4F at 20 V for 30 min at 25 ℃. Development of titanium dioxide nanotube array as a fiber coating for solid-phase microextraction coupled to high performance liquid chromatography for sensitive determination of polycyclic aromatic hydrocarbons (PAHs) in water. Under the optimized SPME conditions, this method has a higher sensitivity, wider linear range, better selectivity and repetition, and was easier to operate. The proposed method was successfully applied to the preconcentration and determination of target PAHs in river water and wastewater samples with satisfactory analytical results.

Key words: titanium dioxide nanotube, assemble, solid phase microextraction, polycyclic aromatic hydrocarbons