应用化学 ›› 2019, Vol. 36 ›› Issue (12): 1413-1421.DOI: 10.11944/j.issn.1000-0518.2019.12.190077

• 研究论文 • 上一篇    下一篇

钙蒙脱土吸附镧的影响因素及其应用

周凤珍,李文秋,王文静,郭惠玲   

  1. 湖北工业大学生物工程与食品学院 武汉 430068
  • 收稿日期:2019-03-22 接受日期:2019-07-03 出版日期:2019-12-01 发布日期:2019-12-10
  • 通讯作者: 郭惠玲
  • 基金资助:
    国家自然科学基金(21401051)湖北省自然科学基金(2014CFB595)资助

Influencing Factors of Lanthanum Adsorption by Ca-Montmorillonite and Its Application

ZHOU Fengzhen,LI Wenqiu,WANG Wenjing,GUO Huiling   

  1. Hubei University of Technology, School of Bioengineering and Food,Wuhan 430068,China
  • Received:2019-03-22 Accepted:2019-07-03 Published:2019-12-01 Online:2019-12-10
  • Contact: GUO Huiling
  • Supported by:
    Supported by the National Natural Science Foundation of China (No. 21401051) and the Natural Science Foundation of Hubei Province (No. 2014CFB595)

摘要:

以钙基蒙脱土(Ca-MMT)为载体,研究其对镧(La)的吸附。 采用X射线衍射仪(XRD)、扫描电子显微镜(SEM)和元素mapping分析、傅里叶红外光谱(FT-IR)、BET、X射线荧光光谱分析(XRF)对其晶型结构、表面形态、比表面积、化学结构进行表征,考察了La的初始浓度、pH值、温度对Ca-MMT吸附镧性能的影响,考察了载镧钙基蒙脱土(Ca-MMT@La)的除磷效果。 结果表明:Ca-MMT投入量为10 g/L时,Ca-MMT的平衡吸附量随镧的初始浓度增加而增大,最大吸附量为49.62 mg/g;随着pH值增大,吸附能力增强,pH=6时为最佳pH吸附镧条件,吸附量为38.36 mg/g;随温度的升高,其吸附量先下降再上升,20 ℃吸附能力最大,吸附量为41.23 mg/g。 Langmuir等温吸附方程推断其吸附属于单分子层吸附。 Ca-MMT不具有吸附磷效果,而Ca-MMT@La对磷酸根有很强的吸附能力,吸附量为7.24 mg/g,除磷率为72.41%,其除磷率随含镧量增大而增大。

关键词: 钙基蒙脱土, 吸附剂, 镧, 废水处理, 吸附效果

Abstract:

The adsorption of lanthanum on Ca-montmorillonite was studied. The crystal structure, surface morphology, specific surface area and chemical structure of Ca-montmorillonite were characterized by XRD, SEM, BET, Fourier transform infrared spectrum (FT-IR) and X-Ray fluorescence (XRF). The effects of initial lanthanum concentration, pH and adsorption temperature on the adsorption of La onto Ca-montmorillonite were examined when the mass concentration of Ca-montmorillonite was 10 g/L. The phosphorus removal effect of Ca-MMT@La was studied. The results showed that the adsorption of La onto Ca-montmorillonite increases with initial lanthanum concentration increasing, and the maximum adsorption capacity is 49.62 mg/g. With the increase of the pH of lanthanum-containing solution, the adsorption capacity increases and the optimum adsorption is obtained at initial pH 6 with the adsorption capacity of 38.36 mg/g. With the increase of temperature, the adsorption capacity increases firstly and then decreases. The maximum adsorption capacity of lanthanum is 41.23 mg/g at 20 ℃. The adsorption equilibrium was best described by the Langmuir isotherm model. The result indicated that La is adsorbed onto Ca-montmorillonite through the monolayer adsorption. Ca-montmorillonite can not adsorb phosphorus. However, Ca-MMT@La has a strong adsorption capacity for phosphate with the adsorption capacity of 7.24 mg/g and the phosphorus removal rate of 72.41%. The adsorption of phosphorus onto Ca-MMT@La increases with the increase of loaded lanthanum content.

Key words: Ca-montmorillonite, adsorbent, lanthanum, wastewater treatment, adsorption effect