应用化学 ›› 2017, Vol. 34 ›› Issue (5): 519-526.DOI: 10.11944/j.issn.1000-0518.2017.05.160505

• 研究论文 • 上一篇    下一篇

金纳米棒负载的静电纺丝纤维的制备及其表面增强拉曼光谱性能

颜照东ab,李洋ab,张涛ab,刘志承ab,刘亚青ab*()   

  1. a中北大学材料科学与工程学院,纳米功能复合材料山西省重点实验室
    b山西省高分子复合材料工程技术研究中心 太原 030051
  • 收稿日期:2016-12-13 接受日期:2017-02-17 出版日期:2017-05-02 发布日期:2017-05-02
  • 通讯作者: 刘亚青
  • 基金资助:
    山西省高等学校科技创新项目(2015161)纳米功能复合材料山西省重点实验室开放基金(NFCM201604)及山西省青年科技研究基金(201601D021035)资助

Gold Nanorod-loaded Electrospun Fibers:Preparation and Surface-enhanced Raman Spectroscopy Performance

YAN Zhaodongab,LI Yangab,ZHANG Taoab,LIU Zhichengab,LIU Yaqingab*()   

  1. aSchool of Material Science and Engineering,North University of China,Shanxi Province Key Laboratory of Functional Nano Composites
    bResearch Center for Engineering Technology of Polymeric Composites of Shanxi Province,Taiyuan 030051,China
  • Received:2016-12-13 Accepted:2017-02-17 Published:2017-05-02 Online:2017-05-02
  • Contact: LIU Yaqing
  • Supported by:
    Supported by Programs of Higher Education Institutions in Shanxi(No.2015161), Open funding of the Shanxi Province Key Laboratory of Functional Nanocomposites and Scientific and Technological Innovation(No.NFCM201604), Shanxi Province Science Foundation for Youths(No.201601D021035)

摘要:

为简单有效地制备高活性表面增强拉曼光谱(Surface-enhanced Raman Spectroscopy,SERS)基底。 本文采用静电纺丝聚乙烯醇(PVA)/聚丙烯酸(PAA)纳米纤维为支撑材料,通过直接浸泡的方法,利用金纳米棒与电纺纤维之间的静电力,使纳米棒在纤维表面自组装,得到了性能优异的SERS基底。 通过透射电子显微镜、扫描电子显微镜对金纳米棒以及不同状态下的电纺纤维的形貌进行表征,结果表明,金纳米棒均匀且密集地负载在纤维表面。 通过设置不同的浸泡时间确定了金纳米棒组装平衡的时间为12 h,并通过调控纺丝时间和金纳米棒的浓度发现随着纺丝时间和金纳米棒浓度的增加,复合纤维膜SERS增强效果随之提升。 该复合纤维膜具有优异的SERS均匀性,并且能够检测到浓度低至10-10 mol/L的4-氨基苯硫酚的存在。

关键词: 金纳米棒, 电纺纤维, 静电力, 自组装, SERS基底

Abstract:

In this work, the highly active surface-enhanced Raman spectroscopy(SERS) substrate was fabricated by a simple and effective method. Electrospun polyvinyl alcohol(PVA)/polyacrylic acid(PAA) nanofibers were used as supporting material and a SERS substrate with excellent performance was obtained by a direct-immersed method due to the electrostatic force between gold nanorods and nanofibers. The morphologies of gold nanorods and electrospun fibers in different states were characterized by transmission electron microscopy and scanning electron microscopy. Gold nanorods are loaded uniformly and densely on the surface of fibers. The optimal assembly time of gold nanorods is 12 hours. By adjusting the spinning time and the concentration of gold nanorods, it was found that the SERS signal of the composite fiber membrane increased with the increase of the spinning time and the concentration of gold nanorods. The composite fiber membrane shows excellent SERS uniformity and the 4-aminothiophenol at a concentration of 10-10 mol/L can be detected.

Key words: gold nanorods, electrospunfibers, electrostaticforce, self-assembly, surface-enhanced Raman spectroscopy substrate