应用化学 ›› 2016, Vol. 33 ›› Issue (3): 320-329.DOI: 10.11944/j.issn.1000-0518.2016.03.150258

• 研究论文 • 上一篇    下一篇

Keggin型铬取代的磷钨杂多阴离子/二氧化钛纳米膜光催化剂的制备及可见光催化性能

邹晓梅,陈艳,朱兴旺,刘高鹏,郭心玮,雷琴,柯小雪,李帅星,华英杰(),王崇太()   

  1. 海南师范大学化学与化工学院 海口 571158
  • 收稿日期:2015-07-21 接受日期:2015-11-18 出版日期:2016-03-02 发布日期:2016-03-02
  • 通讯作者: 华英杰,王崇太
  • 基金资助:
    国家自然科学基金(21161007)海南省国际科技合作重点项目(2012-GH004,KJHZ2014-08)海南省应用技术研究与开发专项(ZDXM20130088,ZDXM2014099)国家大学生创新项目(201411658027)海南省大学生创新项目(20140055)

Preparation of the Keggin Type Chromium Substituted Phosphotungstates/Titanium Dioxide Nano Film and Its Visible Photocatalytic Performance

ZOU Xiaomei,CHEN Yan,ZHU Xingwang,LIU Gaopeng,GUO Xinwei,LEI Qin,KE Xiaoxue,LI Shuaixing,HUA Yingjie(),WANG Chongtai()   

  1. School of Chemistry and Chemical Engineering,Hainan Normal University,Haikou 571158,China
  • Received:2015-07-21 Accepted:2015-11-18 Published:2016-03-02 Online:2016-03-02
  • Contact: HUA Yingjie,WANG Chongtai
  • Supported by:
    Supported by the National Natural Science Foundation of China(No.21161007), the Key International Science and Technology Foundation of Hainan Province(No.2012-GH004, No.KJHZ2014-08), the Research and Development of Applied Technology of Hainan Province(No.ZDXM20130088, No.ZDXM2014099), the National Undergraduate Innovation Project(No.201411658027), the Undergraduate Innovation Project of Hainan Province(No.20140055)

摘要:

以钛酸四丁酯Ti(OC4H9)4为TiO2前驱体,Keggin型铬取代的杂多阴离子PW11Cr为可见光活性组分,采用溶胶-凝胶提拉法在玻片表面制备了PW11Cr/TiO2纳米膜光催化剂,并用UV-Vis DRS、IR、XRD、SEM和TEM等技术手段对催化剂的光吸收性质、化学组成、晶相和表面结构形貌等进行了表征;讨论了膜中PW11Cr和TiO2相互作用的方式;以染料模型污染物RhB的可见光催化降解为探针,评估了PW11Cr/TiO2光催化剂的可见光催化活性,讨论了光催化反应机理,并与TiO2的光催化反应机理进行了比较;考察了焙烧温度、PW11Cr剂量和溶液pH值对光催化活性的影响;最后用RhB的循环降解实验评估了催化剂的光催化稳定性。 实验结果表明,PW11Cr/TiO2光催化剂对可见光有明显吸收,较低焙烧温度(100 ℃)下得到的膜为无定形结构,而较高焙烧温度(500 ℃)为纳晶结构;前者的光催化活性较高,在200 W金卤灯照射下降解10 μmol/L RhB,120 min的降解率为95%,4 h的COD去除率为72%;羟基自由基是导致RhB降解的主要氧活性物质;低的膜处理温度,高的PW11Cr负载量和溶液酸性有利于提高PW11Cr/TiO2膜的光催化活性;经循环重复使用10次,PW11Cr/TiO2膜的光催化活性仅有较少损失。

关键词: Keggin型铬取代磷钨杂多阴离子, 二氧化钛, 可见光催化剂, 溶胶-凝胶法, 罗丹明B

Abstract:

A PW11Cr/TiO2 nano film photocatalyst was prepared on the surface of a glass slide via the sol-gel dipping pulling method using tetrabutyl titanate Ti(OC4H9)4 as the precursor of TiO2 and the Keggin type chromium substituted heteropolyanion(PW11Cr) as the visible light active component. Then the light absorption properties, chemical composition, crystal phase and surface morphology of the as-prepared catalyst were characterized using solid ultraviolet-visible diffuse reflection spectroscopy, infrared spectroscopy, X-ray diffraction, scanning electron microscopy and transmission electron microscopy. The interaction between PW11Cr and TiO2 in the film was discussed. Visible photocatalytic activity of the catalyst was assessed using photocatalytic degradation of RhB as a probe. Meanwhile, a photocatalysis mechanism was suggested and compared with that of TiO2. Influences of the calcination temperature, the PW11Cr dosage and the solution pH on the catalyst activity were also examined. In the end, a recycle test of the catalyst for RhB degradation was employed to evaluate the stability of the catalyst. The PW11Cr/TiO2 photocatalyst has a good absorption of visible light. The film obtained at low calcination temperature(100 ℃) is amorphous but crystal at high calcination temperature(500 ℃). The former has higher photocatalytic activity, and is employed to degrade RhB with a concentration of 10 μmol/L under the irradiation of 200 W metal halide lamp. The degradation ratio is 95% at 120 min and the COD removal is 72% at 4 h. The hydroxyl radicals are the main reactive oxygen species leading to RhB degradation. Low processing temperature, high PW11Cr dosage and high solution acidity are favorable to enhance the photocatalytic activity of the PW11Cr/TiO2 film. After recycles of 10 times for RhB degradaion, the photocatalytic activity of the PW11Cr/TiO2 film lose insignificantly.

Key words: Keggin-type Cr-substituted phosphotungstates, titanium dioxide, visible photocatalyst, sol-gel method, rhodamine B