应用化学 ›› 2019, Vol. 36 ›› Issue (6): 683-689.DOI: 10.11944/j.issn.1000-0518.2019.06.180327

• 研究论文 • 上一篇    下一篇

Ca2+离子掺杂对γ-Ce2S3合成温度及热稳定性的影响

王竹梅,马振国,李月明(),高轶群,宋福生,沈宗洋,李志科   

  1. 景德镇陶瓷大学材料科学与工程学院 ,中国轻工业功能陶瓷材料重点实验室 江西 景德镇 333403
  • 收稿日期:2018-10-12 接受日期:2018-12-24 出版日期:2019-06-01 发布日期:2019-06-03
  • 通讯作者: 李月明
  • 基金资助:
    国家自然科学基金(51462010)和江西省自然科学基金(2017ACB20022)项目资助

Effect of Ca2+-Doping on Synthesis Temperature and Heat Stability of γ-Ce2S3

WANG Zhumei,MA Zhenguo,LI Yueming(),GAO Yiqun,SONG Fusheng,SHEN Zongyang,LI Zhike   

  1. China National Light Industry Key Laboratory of Functional Ceramic Materials,School of Materials Science and Engineering,Jingdezhen Ceramic Institute,Jingdezhen,Jiangxi 333403,China
  • Received:2018-10-12 Accepted:2018-12-24 Published:2019-06-01 Online:2019-06-03
  • Contact: LI Yueming
  • Supported by:
    Supported by the National Natural Science Foundation of China(No.51462010), the Natural Science Foundation of Jiangxi Province of China(No.2017ACB20022)

摘要:

以CeCl3·7H2O、CaCl2·2H2O和C2H2O4·2H2O为原料,在制备钙铈氧化物前驱体基础上,再以Ar气为载气、CS2为硫源对钙铈氧化物前驱体进行硫化合成Ca2+掺杂的γ-Ce2S3色料。 通过X射线衍射(XRD)、紫外-可见漫反射光谱(UV-Vis)及差热-热重分析(TG-DTA)等技术手段表征了色料的结构和性能。 结果表明,Ca2+掺杂能够明显降低γ-Ce2S3的合成温度,当n(Ca2+):n(Ce3+)≥0.16时,在900 ℃硫化150 min即可获得纯相的γ-Ce2S3,与不掺杂时合成γ-Ce2S3的温度相比降低了300 ℃左右。 同时,Ca2+掺杂能够提升γ-Ce2S3的抗氧化能力,当n(Ca2+):n(Ce3+)=0.64时,氧化放热峰的温度由不掺杂时的490.6 ℃提高至541.0 ℃。

关键词: γ-Ce2S3;, 红色料, 钙掺杂, 合成温度, 稳定性

Abstract:

CeCl3·7H2O, CaCl2·2H2O and C2H2O4·2H2O were used as raw materials to prepare Ca2+-doped cerium oxalate by the coprecipitation method. The Ca2+-doped cerium oxalate was calcined to obtain Ca2+-doped cerium oxide precursor. Ca2+-doped γ-Ce2S3 was achieved by vulcanizing precursors in an Ar atmosphere using CS2 as the sulfur source. Pigments were characterized by X-ray diffraction(XRD), energy dispersive spectrometer(EDS), color analyzer, UV-Vis spectrophotometer and thermogravimetric analysis-differential thermal analysis(TG-DTA). The results show that Ca2+-doping can lower the synthesis temperature and improve the thermal stability of pigments in air. When the ratio of n(Ca2+):n(Ce3+)≥0.16, pure phase γ-Ce2S3 can be obtained by vulcanizing at 900 ℃ for 150 min. The synthesis temperature of doped γ-Ce2S3 decrease by 300 ℃ compared with undoped γ-Ce2S3. When the n(Ca2+):n(Ce3+) is 0.64, the oxidation exothermic peak of Ca2+-doped γ-Ce2S3 increases from 490.6 to 541.0 ℃.

Key words: γ-cerium sesquisulfide;, red pigment, calcium doping, synthesis temperature, stability