应用化学 ›› 2018, Vol. 35 ›› Issue (4): 484-490.DOI: 10.11944/j.issn.1000-0518.2018.04.170107

• 研究论文 • 上一篇    

基于纳米金增敏的双酚A二氧化钛凝胶分子印迹电化学传感器的制备及应用

李玲玲,杨绍明(),丁绍卿,尚培玲,杨杰,曹嫱,查文玲   

  1. 华东交通大学材料学院 南昌 330013
  • 收稿日期:2017-04-12 接受日期:2017-06-23 出版日期:2018-03-30 发布日期:2018-04-02
  • 通讯作者: 杨绍明
  • 基金资助:
    国家自然科学基金资助项目(21465012)江西省自然科学基金项目(20171BAB203017)江西省教育厅科技项目(GJJ150544)和华东交通大学校立项目(15LX03)

Preparation and Application of Bisphenol-A TiO2 Gel Molecularly Imprinted Electrochemical Sensor Based on the Sensitivity-Enhancement of Gold Nanoparticles

Lingling LI,Shaoming YANG(),Shaoqing DING,Peiling SHANG,Jie YANG,Qiang CAO,Wenling ZHA   

  1. School of Materials Science and Engineering,East China Jiaotong University,Nanchang 330013,China
  • Received:2017-04-12 Accepted:2017-06-23 Published:2018-03-30 Online:2018-04-02
  • Contact: Shaoming YANG
  • Supported by:
    Supported by the National Natural Science Foundation of China(No.21465012), Natural Science Foundation of Jiangxi Province of China(No.20171BAB203017), Scientific Research Fund of Jiangxi Provincial Education Department(No.GJJ150544), Scientific Research Project of East China Jiaotong University(No.15LX03)

摘要:

以纳米金(AuNPs)为增敏材料,双酚A(BPA)为模板分子,结合表面溶胶凝胶法和自组装法,制备了BPA纳米金-TiO2凝胶分子印迹电化学传感器。 利用扫描电子显微镜和能谱对AuNPs进行了表征,利用红外光谱仪对TiO2凝胶、BPA以及BPA印迹TiO2凝胶进行表征。在最优条件下,该传感器对BPA在1.0×10-8~1.0×10-5 mol/L浓度范围内具有良好的线性关系,线性相关系数为0.995,检测限为0.6×10-8 mol/L,并将该分子印迹传感器应用于实际样品中BPA的分析检测,其回收率为97.4%~103%。

关键词: 纳米金, 双酚A, TiO2, 溶胶凝胶法, 自组装法, 分子印迹传感器

Abstract:

A bisphenol-A(BPA) TiO2 gel molecularly imprinted electrochemical sensor was fabricated using gold nanoparticles(AuNPs) as sensitivity-enhanced materials based on surface sol-gel and self-assembly methods. AuNPs were characterized by scanning electron microscopy(SEM) and energy dispersive spectroscopy. BPA, TiO2 gel, and BPA-imprinted TiO2 gel were characterized by Fourier transform infrared(FTIR) spectrometry. Under optimal conditions, the sensor exhibits a good linear response from 1.0×10-8 to 1.0×10-5 mol/L for bisphenol A, with correlation coefficient 0.995 and a low detection limit of 0.6×10-8 mol/L(S/N=3). The prepared sensor was successfully applied in the detection of actual sample with 97.4%~103% recoveries.

Key words: gold nanoparticles, bisphenol A, TiO2, sol-gel method, self-assembly method, molecularly imprinted sensor