应用化学 ›› 2015, Vol. 32 ›› Issue (10): 1177-1183.DOI: 10.11944/j.issn.1000-0518.2015.10.150087

• 研究论文 • 上一篇    下一篇

氢气泡模板法制备多孔镍用于电催化氧化乙醇

张文彬ab*(),张长财a   

  1. a宜春学院化学与生物工程学院
    b江西省高校锂电新能源工程技术研究中心 江西 宜春 336000
  • 收稿日期:2015-03-09 接受日期:2015-06-25 出版日期:2015-10-10 发布日期:2015-10-10
  • 通讯作者: 张文彬
  • 基金资助:
    国家自然科学基金(21303158)江西省教育厅科学技术研究项目(赣教技字12701号)资助

Electrocatalytic Oxidation of Ethanol Using Porous Nickel Prepared by Hydrogen Bubble Template

ZHANG Wenbinab*(),ZHANG Zhangcaia   

  1. aCollege of Chemistry and Bio-engineering,Yichun University
    bEngineering Center of Jiangxi University for Lithium Energy,Yichun,Jiangxi 336000,China
  • Received:2015-03-09 Accepted:2015-06-25 Published:2015-10-10 Online:2015-10-10
  • Contact: ZHANG Wenbin
  • Supported by:
    Supported by the National Natural Science Foundation of China(No.21303158), Science and Technology Foundation of Ministry of Education of Jiangxi Province(No.12701)

摘要:

多孔镍通过同时在水溶液中析出氢气及还原镍离子电沉积生成,其在强碱溶液中对乙醇表现出良好的电催化氧化效果。 在1 mol/L KOH溶液中,多孔镍的电极反应为准可逆的β-氢氧化镍与β-羟基氧化镍之间质子耦合电子转移。 循环伏安图显示峰值电流密度与电势扫描速度平方根成线性关系,据此计算可得多孔镍的质子扩散系数值为2.92×10-8 cm2/s,其高于块状镍体系的质子扩散系数值约4个数量级,这可能由真实表面积增大导致。 循环伏安法和计时电流法用来表征多孔镍对乙醇的电催化氧化能力,相对于(220)镍电极,多孔镍表现出更高的催化效率,计时电流法测量的催化反应速率常数为7.17×103 cm3/(mol·s)。

关键词: 氢气泡模板法, 多孔镍, 电催化氧化, 乙醇

Abstract:

Porous nickel was electrodeposited by the reduction of nickel ions with the evolution of hydrogen bubble in aqueous solution. This material shows outstanding performance for electrocatalytic oxidation of ethanol in a strong base solution. Quasi-reversible proton coupled electron transfer reaction between β-Ni(OH)2and β-NiOOH is observed for porous nickel in 1 mol/L KOH solution. From the cyclic voltammograms, a linear relationship between peak current density and square root of potential scan rate is obtained. Based on this relationship, proton diffusion coefficient is calculated to be 2.92×10-8 cm2/s for porous nickel, which is four order of magnitude higher than that for bulk nickel due to the increased real surface area. Cyclic voltammetry and chronoamperometry have been used to characterize the electrocatalytic oxidation ability of porous nickel toward ethanol. In comparison to Ni(220), porous nickel gives a higher catalytic efficiency. The catalytic reaction rate constant is measured to be 7.17×103 cm3/(mol·s) by chronoamperometry.

Key words: hydrogen bubble template method, porous nickel, electrocatalytic oxidation, ethanol