应用化学 ›› 1998, Vol. 0 ›› Issue (6): 37-40.

• 研究论文 • 上一篇    下一篇

磷的掺杂对碳负极材料性能的影响

吴宇平1, 方世璧2, 江英彦2, 万春荣1   

  1. 1. 清华大学核能技术设计研究院 北京102201;
    2. 中国科学院化学研究所 北京
  • 收稿日期:1998-03-23 修回日期:1998-09-02 出版日期:1998-12-10 发布日期:1998-12-10
  • 基金资助:
    国家自然科学基金

Effects of Dopped Phosphorus on Carbon Anode's Property

Wu Yuping1, Fang Shibi2, Jiang Yingyan2, Wan Chunrong1   

  1. 1. Tsinghua University, Beijing 102201;
    2. Institute of Chemistry, Chinese Academy of Sciences, Beijing
  • Received:1998-03-23 Revised:1998-09-02 Published:1998-12-10 Online:1998-12-10

摘要: 研究了磷酸的引入对以聚丙烯腈为基体碳负极材料性能的影响。元素分析、XPS及XRD分析结果表明,磷在碳材料中与碳及氧原子相结合。磷酸的引入在较低的温度(600℃)下有利于聚丙烯腈-CN基的环化、脱氢碳化过程,使氮的含量及graphene氮的相对含量增加,磷的键合使碳材料的层间距反而增加,因此位于0.9V以上及以下的可逆容量均随磷酸的加入量的增加而增加,总的可逆容量高达524mAh/g.而在较高的温度(1000℃)下,碳化程度变化不大,主要表现为磷原子的掺杂效果,其引入使位于1.0V左右的可逆容量增加.

关键词: 锂离子二次电池, 碳负极, 磷掺杂

Abstract: The effects of incorporation of phosphoric acid on the carbonaceous materials have been investigated. Results of elemental analysis, XPS and XRD measurements show that phosphorus is in bond with carbon and oxygen atoms. At 600 , the incorporated phosphoric acid favors the cyclization, dehydrogenation and carbonization processes and both the nitrogen content and graphene nitrogens relative contents are increased. The bondage state of phosphorus leads the interlayer distance d002 of carbon material to increase and the reversible capacity below and above 0.9 V increase with the amount of added phosphoric acid with the total value being up to 524 mAh/g. At 1000 , the carbonization degree is not much changed and the reversible capacity at about 10 V increases as a result of the incorporation of phosphorus atoms.

Key words: lithium ion secondary battery, carbon anode, phosphorus incorporation