应用化学 ›› 1991, Vol. 0 ›› Issue (3): 9-12.

• 研究论文 • 上一篇    下一篇

碳布/聚芳醚酮热塑性复合材料的破坏允限

何天白, 周江, 曲桂杰, 陈天禄, 李滨耀   

  1. 中国科学院长春应用化学研究所高分子物理开放实验室, 长春 130022
  • 收稿日期:1990-04-13 修回日期:1990-07-21 出版日期:1991-06-10 发布日期:1991-06-10
  • 基金资助:
    国家自然科学基金

DAMAGE TOLERANCE OF WOVEN CARBON FIBER REINFORCED POLY(PHENYLENE ETHER KETONE)LAMINATES

He Tianbai, Zhou Jiang, Qu Guijie, Chen Tianlu, Li Binyao   

  1. Laboratory of Polymer Physics, Changchun Institute of Applied Chemistry, Academia Sinica, Changchun 130022
  • Received:1990-04-13 Revised:1990-07-21 Published:1991-06-10 Online:1991-06-10

摘要: 本文研究了碳布增强的聚芳醚酮复合材料的破坏允限。用二碘甲烷增强的x-射线照相法对试件内部的冲击缺陷进行观察,结果表明,其破坏类型可分为分层、基体开裂、纤维断裂和脱胶。用三点弯曲方法测定了损伤试件的剩余弯曲强度与冲击能量的关系。

关键词: 热塑性复合材料, 断裂, 破坏允限

Abstract: Damage tolerance of woven carbon fiber reinforced poly(phenylene ether ketone)(woven CF/PEK-C) laminates has been studied on bending after falling-weight impact.Woven CF/PEK-C laminates were obtained by stacking PEK-C films with carbon cloth andthen consolidating at temperature above Tg of PEK-C.The penetrant-enhanced x-radiogra-phy was used to determine the locations and extents of delaminations and matrix crackscaused by impact.It is shown that the damage mode of woven CF/PEK-C can be classifiedinto delamination, matrix crack, fiber breakage and debonding between fibers and thematrix.The residual flexural strength of a damaged laminate for the highest impact energywas about 50% of that before damaging.

Key words: thermoplastic composite, fracture, damage tolerance